: This one is particularly important for streaming to YouTube. A lower figure will reduce upload bandwidth, in exchange for a lower quality video. If you omit them, raspivid will use the full 1920x1080 high definition resolution (1080p). : These can be used to specify width and height. If performance is an issue, however, you may prefer to reduce this to improve steaming. For the best results it should be over 24, which is the speed movies traditionally ran at in order to create the illusion of movement. That long command above can be quite confusing to the untrained eye but features a collection of separate parameters. If everything has worked as intended, you'll end up with something like this: Remember to change for the Stream key you made a note of earlier.

Now, if you want to go ahead and just run it, then copy the code, paste it into your terminal window, and hit enter. The command, however, is long: raspivid -o -t 0 -vf -hf -fps 30 -b 6000000 | avconv -re -ar 44100 -ac 2 -acodec pcm_s16le -f s16le -ac 2 -i /dev/zero -f h264 -i -vcodec copy -acodec aac -ab 128k -g 50 -strict experimental -f flv rtmp://a./live2/Īs you can see, it has a lot of elements to it.

You'll need the stream name/key that you noted down earlier for this. With avconv installed, you're ready to create the feed for YouTube. However, if you don't want to upgrade your Raspberry Pi, you can simply install the libav-tools package: sudo apt install libav-tools The most recent versions of Raspbian have avconv preinstalled, so you shouldn't need to install it.

Best free encoder for youtube live